Category Archives: Pressure Washer Maintenance

Prepare your pressure washer for extended storage time

Posted on November 29, 2011 by Hydro Tek

In the event that the pressure washer is not to be used for an extended period of time (winter) store in a heated space or anti-freeze the unit. With water off run the machine until the float tank is near empty. Fill … Continue reading →

Posted in Pressure Washer Maintenance, Technical Information | Tagged , , | Leave a comment

SCAQMD Information about pressure washers

Posted on October 7, 2011 by Hydro Tek

Here is some information that we have come across that pertains to pressure washer emission standards in California. Other parts of the country can expect to see similar regulations soon if they are not already in place. Southern California AQMD … Continue reading →

Posted in Pressure Washer Distributors, Pressure Washer Maintenance, Service Updates, Technical Information | Tagged , , , , , | Leave a comment

Engine Warranty

Posted on July 22, 2011 by Hydro Tek

Honda and Vanguard Engine Warranty Extended – The warranty on Honda and Vanguard engines we currently use on Hydro Tek pressure washers has increased from 2 years to a 3 year warranty provided by engine manufacturer.

Posted in Pressure Washer Maintenance, Product Updates, Service Updates | Tagged , | Leave a comment

Pressure Washer Service School

Posted on April 29, 2011 by Hydro Tek

:  Service School Recap: The Hydro Tek service school was held on March 24 & 25. Eleven service technicians spent a full day in the classroom and half a day getting their hands dirty troubleshooting equipment and components.We would like … Continue reading →

Posted in Pressure Washer Maintenance, Technical Information | Tagged , , | Leave a comment

COIL LIFTING TOOL

Posted on April 27, 2011 by Hydro Tek

Please make note of the newly available Coil Lifting Tool that can be used to assist in the removal & repair of horizontal coil assemblies. The shape of the tool also allows the coil to be held up in a … Continue reading →

Posted in Pressure Washer Maintenance, Technical Information | Tagged , , | Leave a comment

BURNER CONTROL

Posted on April 12, 2011 by Hydro Tek

Please be aware of the safety hazards & control limitations when running pressure sensitive unloaders without a flow or vacuum switch for burner control. Dangerous steam explosions can occur if check-valve components in the pressure sensitive unloader fail in a … Continue reading →

Posted in Pressure Washer Maintenance, Technical Information | Tagged , | Leave a comment

Pressure Washer Sales Tip

Posted on January 31, 2011 by Hydro Tek

When you sell a pressure washer, don’t forget to sell the service and parts business too. Continue reading →

Posted in Pressure Washer Distributors, Pressure Washer Maintenance | Tagged , , | Leave a comment

Tire pressure safety

Posted on January 25, 2011 by Hydro Tek

Here are a few reminders everyone when checking & refilling pressure washer tires with air: Use caution when filling tires (or anything else) with air. Be aware that large forces are developing in front of you, that can easily injure … Continue reading →

Posted in Pressure Washer Maintenance | Tagged , | Leave a comment

Maintenance reminder about the four major 12VDC burner igniter killers

Posted on April 14, 2010 by Hydro Tek

Four pressure washer burner killers are: 1) Improper burner electrode gap (the electrode gap should not exceed ¼ inch) 2) Excessive heat exposure to igniter (the maximum sustained heat of components 140º, see below) 3) Dirt accumulation on the burner … Continue reading →

Posted in Pressure Washer Maintenance, Service Updates, Technical Information | Tagged , | Leave a comment